X1286 Datasheet PDF - Intersil Corporation

www.Datasheet-PDF.com

X1286
Intersil Corporation

Part Number X1286
Description Intersil Real Time Clock/Calendar/CPU Supervisor with EEPROM X1286
Page 26 Pages


X1286 datasheet pdf
Download PDF
X1286 pdf
View PDF for Mobile


No Preview Available !

New Features
Repetitive Alarms &
Temperature Compensation
2-Wire™ RTC, 256K (32K x 8)
®
Intersil Real Time Clock/Calendar/CPU Supervisor with EEPROM X1286
FEATURES
• Real Time Clock/Calendar
— Tracks time in Hours, Minutes, Seconds and Hun-
dredths of a Second
— Day of the Week, Day, Month, and Year
• 2 Polled Alarms (Non-volatile)
— Settable on the Second, Minute, Hour, Day of the
Week, Day, or Month
— Repeat Mode (periodic interrupts)
• Oscillator Compensation on chip
— Internal feedback resistor and compensation
capacitors
— 64 position Digitally Controlled Trim Capacitor
— 6 digital frequency adjustment settings to
±30ppm
• Battery Switch or Super Cap Input
• 32K x 8 Bits of EEPROM
— 128-Byte Page Write Mode
— 8 modes of Block Lock™ Protection
— Single Byte Write Capability
• High Reliability
— Data Retention: 100 years
— Endurance: 100,000 cycles per byte
• 2-Wire™ Interface interoperable with I2C*
— 400kHz data transfer rate
• Frequency Output (SW Selectable: Off, 1Hz, 100Hz,
or 32.768kHz)
• Low Power CMOS
— 1.25µA Operating Current (Typical)
• Small Package Options
— 8-Lead EIAJ SOIC and 14-Lead TSSOP
APPLICATIONS
• Utility Meters
• HVAC Equipment
• Audio / Video Components
• Set Top Box / Television
• Modems
• Network Routers, Hubs, Switches, Bridges
• Cellular Infrastructure Equipment
• Fixed Broadband Wireless Equipment
• Pagers / PDA
• POS Equipment
• Test Meters / Fixtures
• Office Automation (Copiers, Fax)
• Home Appliances
• Computer Products
• Other Industrial / Medical / Automotive
BLOCK DIAGRAM
32.768kHz
X1
X2
PHZ/IRQ
Select
SCL
SDA
Serial
Interface
Decoder
Control
Decode
Logic
8
OSC
Compensation
Oscillator
Frequency 1Hz
Divider
Timer
Calendar
Logic
Control/
Registers
(EEPROM)
Status
Registers
(SRAM)
Alarm
Time
Keeping
Registers
(SRAM)
Compare
Alarm Regs
(EEPROM)
256K
EEPROM
ARRAY
*I2C is a Trademark of Philips.
REV 1.1 7/8/04
www.intersil.com
Battery
Switch
Circuitry
VCC
VBACK
1 of 26



No Preview Available !

PIN DESCRIPTIONS
X1286
8-pin EIAJ SOIC
X1
X2
PHZ/IRQ
VSS
1
2
3
4
8
7
6
5
VCC
VBACK
SCL
SDA
14- pin TSSOP
X1
X2
NC
NC
NC
PHZ/IRQ
VSS
1
2
3
4
5
6
7
14 VCC
13 VBACK
12 NC
11 NC
10 NC
9 SCL
8 SDA
ORDERING INFORMATION
VCC Range
2.7–5.5V
Package
8L EIAJ SOIC
14L TSSOP
PART MARK INFORMATION
14-Lead TSSOP
EYWW
XXXXX
1286 = 2.7 to 5.5V, 0 to +70°C
1286I = 2.7 to 5.5V, -40 to +85°C
Operating Temperature Range
0–70°C
-40–85°C
0–70°C
-40–85°C
Part Number
X1286A8
X1286A8I
X1286V14
X1286V14I
8-Lead EIAJ SOIC
X1286
EYWWX
Blank = 2.7 to 5.5V, 0 to +70°C
I = 2.7 to 5.5V, -40 to +85°C
REV 1.1 7/8/04
www.intersil.com
2 of 26



No Preview Available !

X1286
PIN ASSIGNMENTS
Pin Number
EIAJ SOIC TSSOP
11
22
36
47
58
69
7 13
8 14
Symbol
X1
X2
PHZ/IRQ
VSS
SDA
SCL
VBACK
VCC
Brief Description
X1. The X1 pin is the input of an inverting amplifier. An external 32.768kHz quartz
crystal is used with the X1286 to supply a timebase for the real time clock. The
recommended crystal is a Citizen CFS206-32.768KDZF. Internal compensation
circuitry is included to form a complete oscillator circuit. Care should be taken in the
placement of the crystal and the layout of the circuit. Plenty of ground plane around
the device and short traces to X1 are highly recommended. See Application section
for more recommendations.
X2. The X2 pin is the output of an inverting amplifier. An external 32.768kHz
quartz crystal is used with the X1286 to supply a timebase for the real time clock.
The recommended crystal is a Citizen CFS206-32.768KDZF. Internal compensation
circuitry is included to form a complete oscillator circuit. Care should be taken in the
placement of the crystal and the layout of the circuit. Plenty of ground plane around
the device and short traces to X2 are highly recommended. See Application section
for more recommendations.
Programmable Frequency/Interrupt Output – PHZ/IRQ. This is either an
output from the internal oscillator or an interrupt signal output. It is a CMOS
output.
When used as frequency output, this signal has a frequency of 32.768kHz,
100Hz, 1Hz or inactive.
When used as interrupt output, this signal notifies a host processor that an alarm
has occurred and an action is required. It is an active LOW output.
The control bits for this function are FO1 and FO0 and are found in address
0011h of the Clock Control Memory map. See “Programmable Frequency Output
Bits—FO1, FO0” on page 13.
VSS.
Serial Data (SDA). SDA is a bidirectional pin used to transfer data into and out
of the device. It has an open drain output and may be wire ORed with other open
drain or open collector outputs. The input buffer is always active (not gated).
An open drain output requires the use of a pull-up resistor. The output circuitry
controls the fall time of the output signal with the use of a slope controlled pull-
down. The circuit is designed for 400kHz 2-wire interface speed.
Serial Clock (SCL). The SCL input is used to clock all data into and out of the
device. The input buffer on this pin is always active (not gated).
VBACK. This input provides a backup supply voltage to the device. VBACK
supplies power to the device in the event the VCC supply fails. This pin can be
connected to a battery, a Supercap or tied to ground if not used.
VCC.
REV 1.1 7/8/04
www.intersil.com
3 of 26



No Preview Available !

X1286
ABSOLUTE MAXIMUM RATINGS
Temperature Under Bias ................... -65°C to +135°C
Storage Temperature ........................ -65°C to +150°C
Voltage on VCC, VBACK and PHZ/IRQ
pin (respect to ground) ............................-0.5V to 7.0V
Voltage on SCL, SDA, X1 and X2
pin (respect to ground) ............... -0.5V to 7.0V or 0.5V
above VCC or VBACK (whichever is higher)
DC Output Current .............................................. 5 mA
Lead Temperature (Soldering, 10 sec) ...............300°C
Stresses above those listed under “Absolute Maximum
Ratings” may cause permanent damage to the device.
This is a stress rating only and the functional operation
of the device at these or any other conditions above
those indicated in the operational sections of this spec-
ification is not implied. Exposure to absolute maximum
rating conditions for extended periods may affect
device reliability.
DC OPERATING CHARACTERISTICS (Temperature = -40°C to +85°C, unless otherwise stated.)
Symbol
VCC
VBACK
VCB
VBC
Parameter
Main Power Supply
Backup Power Supply
Switch to Backup Supply
Switch to Main Supply
Conditions
Min
Typ
Max
Unit
2.7 5.5 V
1.8 5.5 V
VBACK -0.2
VBACK
VBACK -0.1
VBACK +0.2
V
V
Notes
OPERATING CHARACTERISTICS
Symbol
Parameter
ICC1
Read Active Supply Cur-
rent
ICC2
Program Supply Current
(nonvolatile)
ICC3
Main Timekeeping
Current
IBACK Timekeeping Current
Conditions
VCC = 2.7V
VCC = 5.0V
VCC = 2.7V
VCC = 5.0V
VCC = 2.7V
VCC = 5.0V
VBACK = 1.8V
VBACK = 3.3V
ILI Input Leakage Current
ILO Output Leakage Current
VIL Input LOW Voltage
Min
-0.5
VIH
VHYS
VOL1
VOL2
VOH2
Input HIGH Voltage
Schmitt Trigger Input
Hysteresis
Output LOW Voltage for
SDA
Output LOW Voltage for
PHZ/IRQ
Output HIGH Voltage for
PHZ/IRQ
VCC related level
VCC = 2.7V
VCC = 5.5V
VCC = 2.7V
VCC = 5.5V
VCC = 2.7V
VCC = 5.5V
VCC x 0.7 or
VBACK x 0.7
.05 x VCC or
.05 x VBACK
VCC x 0.7
VCC x 0.7
Typ
1.25
1.5
Max
400
800
2.5
3.0
10
20
10
10
VCC x 0.2 or
VBACK x 0.2
VCC + 0.5 or
VBACK + 0.5
Unit
µA
µA
mA
mA
µA
µA
µA
µA
µA
µA
V
V
V
Notes
1, 5, 7, 14
2, 5, 7, 14
3, 7, 8, 14, 15
3, 6, 9, 14, 15
“See Perfor-
mance Data”
10
10
13
13
13
0.4
0.4
VCC x 0.3
VCC x 0.3
V
V
V
11
11
12
REV 1.1 7/8/04
www.intersil.com
4 of 26



X1286 datasheet pdf
Download PDF
X1286 pdf
View PDF for Mobile


Related : Start with X128 Part Numbers by
X1286 Intersil Real Time Clock/Calendar/CPU Supervisor with EEPROM X1286 X1286
Intersil Corporation
X1286 pdf
X1288 2-Wire RTC Real Time Clock/Calendar/CPU Supervisor with EEPROM X1288
Xicor
X1288 pdf
X1288 RTC Real Time Clock/Calendar/CPU Supervisor X1288
Intersil Corporation
X1288 pdf

Index :   0   1   2   3   4   5   6   7   8   9   A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z   

This is a individually operated, non profit site. If this site is good enough to show, please introduce this site to others.
Since 2010   ::   HOME   ::   Contact