VMIACC-BT10 DIN Rail Transition Module for Euro-DIN C 64-Pin, C 96-Pin, and C/2 32-Pin Connectors
Sept. 27, 2010 800-800563-000 B
A BC D E F
A = Male or Female
0 = Female
1 = Male
BC = Number of Pins
32 = Euro-DIN C/2 32-Pin Connector
64 = Euro-DIN C 64-Pin Connector
96 = Euro-DIN C 96-Pin Connector
For Ordering Information, Call:
1-800-322-3616 or 1-256-880-0444 • FAX (256) 882-0859
Web Address: www.ge-ip.com
Copyright © 2010 GE Intelligent Platforms Embedded Systems, Inc.
All Rights Reserved.
Specifications subject to change without notice.
Introduction: The VMIACC-BT10* DIN rail transition module
provides a high-density, Euro-DIN C connector to three-level
terminal transition in an easy-to-use DIN rail mount form factor.
As shown in Figure 1, the VMIACC-BT10 simplifies field wiring
interfaces by providing convenient lift clamp-style terminals
while preserving the space efficiency of a pin-and-socket I/O
board interface. I/O boards and transition modules can be
interconnected by either cost-effective mass-terminated flat
cables, or by specialty cables as the application demands. The
following GE I/O boards are directly compatible with these
Compatible I/O Boards:
Compatible I/O Cables:
Number of Connector
C/2 32 pin
The ampacity of the transition panel is limited by the DIN
connectors of a 1 A per terminal.
Maximum Current: 1 A per terminal
Maximum Voltage: 125 VAC
Terminal Block Materials
Clamp: Steel, galvanized, and chromated
Wire Protection: CuZn, brass, prenickeled, and 5 μ tin-plated
Screw: Steel, galvanized, and chromated
6.65 in. (C 96), 5.321 in. (C 64 and C/2 32)
2.73 in. (mounted)
Maximum Wire Diameter: Solid wired from 0.2 to 4 mm (12 to
22 AWG). Fine stranded wire from 0.2 to 2.5 mm2 (12 to 24 AWG).
* indicates a trademark of GE Intelligent Platforms, Inc. and/or
its affiliates. All other trademarks are the property of their